PROTECT PLUS M600 Power Modular 3-Phase ups, 30 - 600 KVA

Protect Plus M600 - DescriptionX

Modularity: Evolve with your needs at optimized cost

Your business is constantly evolving and so is your data center infrastructure or production line. The Protect Plus M600 is the right answer to this. It offers a scalable solution by providing the ability to add or remove power modules in the event of growth or decrease of the protected load, complete flexibility, n+x inbuilt redundancy as well as automatic and predictive management of power. Protect Plus M600 combines the best transformer-less IGBT technology with a modular architecture to improve the performance of the whole system. It reduces power losses, energy consumption and operating costs.

Scalable architecture for optimum performance and exibility

The modular and scalable architecture of Protect Plus M600 is designed to maximize savings in terms of foot print (m2), power installed (kVA), electrical system (cabling and protection devices), security (MTTR and MTBF) and most importantly, energy management (kWh and costs). Moreover, it allows for an increase or decrease in power installed depending upon the needs of the load.

Each power module has independent hardware and controlability, able to operate and coordinate with other modules within the system. The control of power modules connected in parallel is decentralized in the single 30 kVA device (no centralized control system). The omission of the master/ slave architecture, eliminates any possibility of a problem due to the failure of a single power module.

The predictive management of installaed power

When using redundant systems (n+1 configuration), it is quite common that a UPS protects light loads, thus decreasing the overall system’s efficiency; in this case the ideal solution is that the UPS may maintain “active” only the power modules that are strictly necessary for the actual critical load (plus the “+1” redundant power module). The modular Protect Plus M600, with its Idle Mode, allows for the ability to “freeze” automatically, and in rotation, the power modules that are not normally used to protect the critical load. Therefore, even with “light” loads, the overall AC/AC efficiency of the UPS system is increased, and at the same time, its level of reliability optimized.

Intelligent management for greater energy saving

The modular Protect Plus M600 from AEG PS has the best IGBT technology and scalable architecture available. The intelligent management of power modules allows the system to reach high AC/AC efficiency values, typically up to 95.5% in double conversion (VFI) and up to 98.5% in ECO mode (VFD), thus ensuring the system’s optimization and reduction of energy waste.