Search Icon

Protect D Single phase in / out UPS system

  • Protect D 3000
  • Protect D 10000 + Battery Pack
1/2

1000 – 10000 VA uninterruptible power supply

With a high power factor of 0.9 the Protect D 1-3 kVA exceeds the power of conventional UPS systems by 20%. Efficiency is significantly increased during normal operation as well as in the energy-efficient ECO operating modes. Protect D 6000 and D 10000 compliment the range of the successful Protect D series. With Protect D 10000, a power level of 10 kVA in rack design is available for the first time. Protect D 6000 and Protect D 10000 have the same advantages and characteristics as the smaller models, including the higher power factor of 1.

Read more

Contact Sales Customer References

Comprehensive UPS protection open

Online UPS topology, also known as double-conversion, provides reliable protection against all 9 kinds of power supply failures. It provides clean power thanks to connected loads that are constantly supplied from the battery.

Energy saving open

Due to its high efficiency, power consumption is very low. Over its product lifetime, the savings in terms of money and power are higher than older systems, making this a good replacement unit.

Scalability open

Parallel operation makes it flexible to adapt the capacity to changing load requirements
  • UPS Topology Double Conversion (VFI)
  • Capacity 1 - 10 kVA
  • Input/Output 1-phase/1-phase
  • Nominal Voltage 220 / 230 / 240 VAC
  • Power Factor 0.9 / 1

Open Navigation

Characteristics

  • VFI topology (online / double conversion) protects against all network problems
  • An increase of the available performance by approx. 20 % through a 0.9 power factor
  • Increased efficiency through the ECO mode • Advanced battery charging technology for maximum durability of the battery
  • Additional battery packs for easy scaling of the autonomy times
  • Extension slot for communication cards; communication in parallel is possible through the RS232 / USB interface and SNMP
  • Low height (2 U) including integrated batteries
  • Switchable UPS outputs for load shedding
  • Display of the UPS parameters on a graphic LCD, direct configuration is possible with the control panel
  • Freely programmable potential-free contact plus emergency shutdown contact 
  • Suitable for IT cabinets with a depth of 800 mm 
  • Usable as rack or tower version

 

Special characteristics of Protect D 6000/10000

  • Very easy assembly through connection unit with manual maintance bypass switch
  • Parallel operation of up to 3 units
  • Output power factor of 1
  • UPS including battery, connection unit with manual bypass fits within 5 standard height units (2U UPS + 3U battery)

 

Still looking for something?