Protect D Single phase in / out UPS system

  • Protect D 3000
  • Protect D 10000 + Battery Pack
1/2

1000 – 10000 VA uninterruptible power supply

With a high power factor of 0.9 the Protect D 1-3 kVA exceeds the power of conventional UPS systems by 20%. Efficiency is significantly increased during normal operation as well as in the energy-efficient ECO operating modes. Protect D 6000 and D 10000 compliment the range of the successful Protect D series. With Protect D 10000, a power level of 10 kVA in rack design is available for the first time. Protect D 6000 and Protect D 10000 have the same advantages and characteristics as the smaller models, including the higher power factor of 1.

Plus

Contact commercial Références clients

Protection ASI complète ouvrir

La topologie ASI « on-line », dite à double conversion, offre une protection fiable contre les 9 types de pannes d’alimentation électrique. Il fournit une énergie propre grâce à des charges connectées alimentées en permanence par la batterie.

Économie d’énergie ouvrir

Grâce à son rendement élevé, la consommation d’énergie est très faible. Au cours de la durée de vie, ce produit permet des économies en terme de coût et d’énergie supérieures à celles des anciens systèmes, ce qui en fait un bon appareil de remplacement.

Évolutivité ouvrir

Le fonctionnement en parallèle permet d’adapter la capacité à l’évolution des besoins en matière de charge
  • UPS Topology Double Conversion (VFI)
  • Capacity 1 - 10 kVA
  • Input/Output 1-phase/1-phase
  • Nominal Voltage 220 / 230 / 240 VAC
  • Backup @25% capacity 17-483 min

Characteristics

  • VFI topology (online / double conversion) protects against all network problems
  • An increase of the available performance by approx. 20 % through a 0.9 power factor
  • Increased efficiency through the ECO mode • Advanced battery charging technology for maximum durability of the battery
  • Additional battery packs for easy scaling of the autonomy times
  • Extension slot for communication cards; communication in parallel is possible through the RS232 / USB interface and SNMP
  • Low height (2 U) including integrated batteries
  • Switchable UPS outputs for load shedding
  • Display of the UPS parameters on a graphic LCD, direct configuration is possible with the control panel
  • Freely programmable potential-free contact plus emergency shutdown contact 
  • Suitable for IT cabinets with a depth of 800 mm 
  • Usable as rack or tower version

 

Special characteristics of Protect D 6000/10000

  • Very easy assembly through connection unit with manual maintance bypass switch
  • Parallel operation of up to 3 units
  • Output power factor of 1
  • UPS including battery, connection unit with manual bypass fits within 5 standard height units (2U UPS + 3U battery)